There were no warning lights prior to the failure. The failure mileage was 119,000 and current mileage was 119,500. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. Then I could pull the pump. This Part Fits: Catalog: B Vehicle Body Engine 2000 Chevrolet Express 3500 Extended Cargo Van 5. We here at Auto Parts Warehouse want to make sure you're happy with your car part purchases.
At Autozone: About this product: Part Number: 19264 Weight: 0. Also, the vehicle will show inaccurate fuel readings. For about 15 bucks, it's the easiest thing to check. If you still don't hear the fuel pump. Upon checking the fuse box the contact noticed that fuel pump fuse had blew out.
They were a common failure problem. I realize truck has now 175000 miles, but I know too many others and have read hundreds of posts on message boards about the exact same problems. The contact crashed into a pole. Having driven several of these vans over several years, 99% of the time, the failure will be the pump itself. You must remove the coverthat protects the gast tank and then the tank itself. He purchased two fuel pumps to make sure exactly what the problem was before he did this work on the vehicle.
The front bumper was damaged. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. This specific vehicle model was not included in the recall. It also has the fuel gauge sensoron it, so if you have been having problems with your gas gauge,this will be fixed as well. .
To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. All Replacement items are backed by a 1-year, unlimited-mileage warranty. Be careful you do not … round off the fuel line nuts when removing. The new module ki 3. For more information, go to. At 65000 miles gas gauge became sporadic.
The vehicle has not been diagnosed by a dealer. It is about the size of one of those small tomato paste cans. Module located on frame rail where it takes all water from lf tire. If you hear nothing, then replace the relay and try again. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. I request this be investigated for a possible recall.
I have verbally been denied any help with the cost of this by the Chevrolet motor division customer assistance center, complaint 1-131209176. There has been a lot of problems with the old setup. Just go ahead and call the phone number at the top of the page and a friendly specialist will help you out. The vehicle was not taken to a dealership. The noise you hear is from the fuel pump in the gas tank. As long as the contact kept the fuel tank below a half a tank this problem did not occur.
There will be a cap on the fuel rail with a service port, don't get it confused with the evap service port, it may be buried but you should be able to see it after looking for a while, when you find it hook you fuel pressure tester to it and crank the engine and it should read around 55 lbs, if you … can't hear it when you start it up you are not getting fuel pressure anyway, check the fuses and inertia switch if it has one. We're here to help with whateveve questions or concerns. I used a thick piece of metal, gasket material and sealer with screws for the next time I might have to do this. If the relay is bad, the pump will not pump. If the relay is okay, and the pump is trying, then it could be the fuel filter, pressure regulator, the injectors or the ignition system.